Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Lubricate the Doors on a Fiat Panda

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Car door

Obtain some WD-40 or similar products to lubricate the hinges and linkages of the various doors. The video clearly demonstrates how to carry out this procedure by lubricating each nut and mechanism involved in the opening and closing of the doors. Remember that in addition to the four doors, you can also lubricate the boot lid and the front bonnet covering the engine compartment. If done frequently, this operation can ensure better functioning and maintenance over the long term, reducing the likelihood of damage.

Updated on 27 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Fuel Pump on a Fiat Panda 4x4 (169)
How to Remove the Fuel Pump on a Fiat Panda 4x4 (169)
Fiat Panda (2003-2012 / 169, MK 2) In this tutorial, you will learn how to remove and replace the fuel pump or low-pressure fuel sender on a Fiat Panda 4x4 (169). First, open the rear …
How to Remove the Air Filter on a Fiat Panda
How to Remove the Air Filter on a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) Before you can start, open the bonnet of your Fiat Panda to access the engine bay. Begin by unfastening the clips that secure the air filter cover. T…
How to Remove the Horn from a Fiat Panda
How to Remove the Horn from a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) Before you can begin, open the front bonnet of your Fiat Panda. Start by unscrewing and removing the screws that secure the front mask, then remove t…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos