Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Windscreen Washer Pump on the Fiat Freemont - Dodge Journey

Model: Fiat Freemont MK 1 - Years: 2011, 2012, 2013, 2014, 2015, 2016
Part: Pump

Video tutorial

This short and simple guide outlines the steps to remove and replace the windscreen washer pump on the Fiat Freemont and Dodge Journey. First, open the bonnet and disconnect the intake hose by unscrewing the clamp screw; then remove the entire air filter box, taking out the filter and unscrewing the screws underneath, as shown in the video.

Next, remove the plastic panel above the bumper; then take out the washer reservoir, draining all the fluid, and subsequently replace the pump, following the video to the end!


Updated on 9 May 2026 by ScegliAuto


Related tutorials

Replacing the Windscreen Washer Fluid Reservoir on a Fiat Freemont - Dodge Journey
Replacing the Windscreen Washer Fluid Reservoir on a Fiat Freemont - Dodge Journey
Fiat Freemont (2011-2016 / MK 1) .. reservoir on a Fiat Freemont, as well as on a Dodge Journey. First, open the bonnet and start by removing the air filter box located on the right;.. …
Removing the Central Grille from a Fiat Freemont and Dodge Journey
Removing the Central Grille from a Fiat Freemont and Dodge Journey
Fiat Freemont (2011-2016 / MK 1) .. the central grille from a Fiat Freemont and a Dodge Journey. First, open the bonnet of your car and remove the plastic clips found on the upper engine.. …
Removing the Rear Light on Fiat Freemont - Dodge Journey
Removing the Rear Light on Fiat Freemont - Dodge Journey
Fiat Freemont (2011-2016 / MK 1) .. to remove the rear light on a Fiat Freemont and a Dodge Journey by following these simple instructions. First, open the boot and unscrew the two fixing.. …

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos