Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Punto
    4. : Guide to replacing the Fiat Punto cylinder head gasket

Fiat Punto - Video tutorial

Model: Fiat Punto MK 2, 188 - Years 1999-2011
Part: Engine head
Operation: Guide to replacing the Fiat Punto cylinder head gasket

Let's see the instructions in this guide that will allow us to disassemble the cylinder head and replace the Fiat Punto gasket. First we go to drain the engine oil, letting it drain into a container; then we remove the front wheel and disconnect the serpentine belt, then removing the timing cover. At this point we remove the timing belt and unscrew the screws of the cylinder head cover; we unscrew the screws of the cylinder head to remove it, then replacing the gasket, following the video to the end!


Posted on 21 April 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Punto 1999-2011 - What is the tightening torque of the cylinder head bolts on the Fiat Punto 1.3 Multijet? Read Answer
    • Punto 1999-2011 - What is the tightening torque of the cylinder head bolts of the Fiat Punto 188 1.2 16v? Read Answer
    • Punto 2005-2018 - How much does the replacement of the cylinder head of the Fiat Punto 1.3 Multijet cost? Read Answer
    • Punto 2005-2018 - How much does it cost to replace the Fiat Punto cylinder head gasket? Read Answer
    • Punto 1999-2011 - Torque for Fiat Punto 1.2 16V cylinder head bolts? Read Answer
    • Punto 2005-2018 - How much does the cylinder head gasket cost on a Fiat Punto Evo 1.3 mjt? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos