Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : How to replace the daytime running lights of the Fiat 500

Fiat 500 - Video tutorial

Model: Fiat 500 312 - Years 2007-2021
Part: Headlight bulb
Operation: How to replace the daytime running lights of the Fiat 500

If one or both of the daytime running lights of your new Fiat 500 have malfunctions or do not come on then you must proceed with their replacement so as not to run into trouble with the law or in danger along the way. Below we will find out what are the steps required to do everything quickly and safely. First, turn off the car completely and go to the wheel cover. Locate the small compartment and remove it. Also remove the protective rubber cap and proceed with disconnecting the electrical connector. At this point all that remains is to remove the faulty bulb and replace it with the new one. Refit the rubber cap and the wheel trim panel and you are done.


Posted on 23 April 2024 by ScegliAuto

    Frequently Asked Questions

    • 500 2007-2021 - Where are the front fog lights of the Fiat 500 mounted? Read Answer
    • 500 2012-2023 - Which dipped beam bulbs are fitted on the Fiat 500L? Read Answer
    • 500 2007-2022 - Why are the daytime running lights of the Fiat 500 not working? Read Answer
    • 500 2007-2021 - The position lights of my Fiat 500 are not working, what can I do? Read Answer
    • 500 1957-1975 - How to replace the headlight bulb in the vintage Fiat 500L? Read Answer
    • 500 1957-1975 - How to replace the headlight bulb on a Fiat 500? Read Answer
    • 500 2012-2023 - How to replace the parking light on a Fiat 500X? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos