Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the drive shaft boot in the Fiat Panda?

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: CV boot

In this tutorial we can see how to replace the drive shaft boot in the Fiat Panda. First of all we lift the front part of the vehicle with a jack, obviously taking all the necessary precautions, then we remove the wheel on the side where we are going to work and unscrew the big nut of the drive shaft with a 36mm socket wrench. Next, we disconnect the steering link, disconnect the stabilizer bar link and unscrew the two shock strut bolts. At this point, we can remove the joint from the drive shaft with the special extractor, unhook the hose clamps and proceed with its replacement.

Posted on 14 June 2022 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the drive shaft boot on the Fiat Panda?
How do you replace the drive shaft boot on the Fiat Panda?
Fiat Panda (2003-2012 / 169, MK 2) In order to replace the drive shaft boot on the Fiat Panda, you must first loosen the bolts that secure the wheel corresponding to the boot that need…
How to remove the driveshaft of the Fiat Panda 4x4.
How to remove the driveshaft of the Fiat Panda 4x4.
Fiat Panda (2003-2012 / 169, MK 2) Let's see in this guide how to disassemble the drive shaft, replacing the oil seal, of the Fiat Panda 4x4. First, we lift the car and begin to unscre…
How to replace the propshaft on Fiat Panda 169 4x4
How to replace the propshaft on Fiat Panda 169 4x4
Fiat Panda (2003-2012 / 169, MK 2) Let's find out in this video the instructions that will allow us to be able to replace the transmission shaft on the Fiat Panda 169 4x4. First of all…

How to Remove the Gear Knob on an Opel Astra

How to replace the gear knob on an Opel Astra? Follow these steps: use a plastic lever to disconnect the leather gaiter frame (if you need to replace it). Grip the knob with both hands and pull it upwards (with a strong and decisive motion) until it comes off the gear stick. For installation: fit the new gaiter and position it on the centre tunnel, take the new knob and push it onto the stick, tightening it until fully threaded. Test the movement of the stick on the centre tunnel to ensure the knob is correctly fitted.

Watch the video!


by ScegliAuto

More videos