Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Gear Gaiter on the Fiat Panda 4x4

Model: Fiat Panda MK 1, 141 - Years: 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991
Part: CV boot

See other generations:
Video tutorial

In today's video tutorial, we will cover the main instructions for dismantling and replacing the gear gaiter on the Fiat Panda 4x4. First, lift the vehicle and start by removing the wheel, unscrewing the bolts. Then, disconnect the wheel arm from the braking system by unscrewing the pin, as illustrated in the video.

At this point, dismantle the driveshaft to later remove the worn gaiter; replace it with the new one and secure it with its clamp, tightening it well, following the video tutorial to the end for reassembly!


Updated on 18 May 2026 by ScegliAuto


Related tutorials

How to Remove the CV Boot on Fiat Panda
How to Remove the CV Boot on Fiat Panda
Fiat Panda (1980-2003 / MK 1, 141) Let’s see how to remove the boot from the joint on a Fiat Panda. After positioning your car on a column lift: raise it to a comfortable height to wor…
How to replace the rear differential silent blocks on the Fiat Panda 4x4?
How to replace the rear differential silent blocks on the Fiat Panda 4x4?
Fiat Panda (2003-2012 / 169, MK 2) To replace the rear differential silent blocks on the Fiat Panda 4x4, first loosen the bolt and nut securing the stabiliser bar at the rear. Once the…
How to Remove the Drive Shaft from a Fiat Panda 4x4
How to Remove the Drive Shaft from a Fiat Panda 4x4
Fiat Panda (2003-2012 / 169, MK 2) In this guide, learn how to dismantle the drive shaft and replace the oil seal on a Fiat Panda 4x4. First, raise the vehicle and start unscrewing all…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos