Do it yourself
Frequently asked questions about cars and motorcycles

Removing the Steering Column and EPS from the Fiat Grande Punto

Model: Fiat Punto MK 3, Punto EVO, 199, Grandepunto - Years 2005-2018

This tutorial video shows how to remove the EPS and steering column from the Fiat Grande Punto, as well as from the Punto Evo. First, get inside the vehicle and start removing all the screws from the dashboard and the steering wheel cover; then remove the latter by taking out the airbag and disconnecting the connector, as shown in the video. At this point, unscrew the screws of the steering position sensor, disconnecting the various electrical connectors; then remove the EPS along with the side stalks. Finally, reassemble everything, following the tutorial video to the end!

Updated on 29 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) This guide provides step-by-step instructions for removing the EPS column from the Fiat Grande Punto, as well as the Punto Evo. First, open the front…
Fiat Punto (1999-2011 / MK 2, 188) How to remove the EPS on a Fiat Punto? Follow these steps. Before removing the steering wheel, disconnect the battery power cables. Use a screwdriver…
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) Here’s how to remove the steering wheel with airbag from a Fiat Grande Punto. This is a straightforward operation; follow this guide. Insert a screwd…

Other guides you may be interested in

    Frequently Asked Questions

    • Punto 2005-2018 - Where is the inertia switch on the Fiat Grande Punto? Read answer
    • Punto 2005-2018 - How many km does the Fiat Punto run in reserve? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos