Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Deactivate and Repair the Immobiliser Contact on the Fiat Ducato JTD

Model: Fiat Ducato - Years 1981-1994

In today's video tutorial, you will learn how to deactivate and repair the immobiliser contact on the Fiat Ducato, following the instructions below. First, get into the vehicle and start by removing the plastic cover of the steering column; then disconnect the electrical connector of the key recognition, as illustrated in the video. This will deactivate the immobiliser system, which will prevent you from starting the vehicle; use a suitable contact cleaner to clean the terminal. Now reconnect the contact and check its operation.

Updated on 14 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Changing the Gear Oil of the Fiat Ducato 2.8 JTD
Changing the Gear Oil of the Fiat Ducato 2.8 JTD
Fiat Ducato (2002-2006 / ) This guide outlines the main steps to replace the transmission oil of the second series Fiat Ducato with a 2.8 JTD engine. First, lift the vehicle an…
How to Start a Fiat Ducato in an Emergency
How to Start a Fiat Ducato in an Emergency
Fiat Ducato (2006-2014 / X250) Today's guide shows how to start a Fiat Ducato in an emergency, particularly how to start the engine if the immobiliser is faulty. First, get inside …
How to Replace the Timing Belt on a Fiat Ducato 2.8 JTD?
How to Replace the Timing Belt on a Fiat Ducato 2.8 JTD?
Fiat Ducato (2002-2006 / ) To replace the timing belt on a Fiat Ducato 2.8 JTD, lift the vehicle to remove the front right wheel and its wheel arch. This will provide access to…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos