Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Brake Pads on a Fiat Scudo Van?

Model: Fiat Scudo MK 2 - Years 2007-2016
Part: Brake pads

In this tutorial, you will see how to replace the rear brake pads on a Fiat Scudo van. First, release the handbrake and lift the side you will be working on with a jack, taking all necessary precautions. Next, remove the wheel and disconnect the cable from the caliper. Then, remove the cable from the support bracket, undo the lower bolt of the caliper, and rotate it upwards, securing it in place with a rope or zip tie. At this point, you can replace the pads, push the piston fully back in, and reassemble everything by following the reverse procedure.

Updated on 20 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to reset the service in a Fiat Scudo van?
How to reset the service in a Fiat Scudo van?
Fiat Scudo (2021-2026 / MK 3) In this tutorial, we will see how to reset the service indicator in the Fiat Scudo van, an operation that is extremely simple and quick, to be done o…
How to Replace the Front Headlamp Bulb on a Fiat Scudo
How to Replace the Front Headlamp Bulb on a Fiat Scudo
Fiat Scudo (1996-2007 / MK 1) To replace the front headlamp bulb on a Fiat Scudo, open the bonnet and remove the protective cap located at the rear of the headlamp. This will allo…
How to Remove the Rear Light and Bulb on a Fiat Scudo
How to Remove the Rear Light and Bulb on a Fiat Scudo
Fiat Scudo (2007-2016 / MK 2) In this video tutorial, you will find instructions on how to remove and replace the rear light and its bulbs on a second-generation Fiat Scudo. First…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos