Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to remove the ignition barrel from the Fiat Ducato - Citroen Jumper - Peugeot Boxer

Model: Fiat Ducato X250 - Years 2006-2014

This guide provides the main instructions to remove and replace the ignition switch or barrel of the Fiat Ducato, as well as the Citroen Jumper and Peugeot Boxer. First, get into the vehicle and start by removing the plastic cover located under the ignition barrel by unscrewing the screws; then remove the two pins of the ignition switch, disconnecting the electrical connector to take it out, as shown in the video. At this point, install the new original barrel, using the new key!

Updated on 21 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Swivel seat on Fiat Ducato, Citroen Jumper, Peugeot Boxer.
Swivel seat on Fiat Ducato, Citroen Jumper, Peugeot Boxer.
Fiat Ducato (2014-2026 / X290) .. front seat - but not only - of the Fiat Ducato, Citroen Jumper and Peugeot Boxer. This accessory is particularly useful for vehicles used as campers... …
How to reset the service light on the Fiat Ducato/Citroen Jumper/Peugeot Boxer
How to reset the service light on the Fiat Ducato/Citroen Jumper/Peugeot Boxer
Fiat Ducato (2006-2014 / X250) To reset the service light on a Fiat Ducato/Citroen Jumper/Peugeot Boxer, follow these steps: turn on the ignition and note that the spanner light is…
Maintenance of the Front Brakes on the Fiat Ducato (Peugeot Boxer, Citroen Relay/Jumper)
Maintenance of the Front Brakes on the Fiat Ducato (Peugeot Boxer, Citroen Relay/Jumper)
Fiat Ducato (2014-2026 / X290) .. brakes on the Fiat Ducato (and its counterparts Peugeot Boxer and Citroen Relay/Jumper) is not complex. Lift the vehicle on axle stands. Remove the.. …

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos