Do it yourself
| ||||
|
Fiat 500 - Video tutorial
Model: Fiat 500
Epoca
- Years 1957-1975 In order to replace the drive shaft boot on a vintage Fiat 500, you need to lift the car with a jack or jack so that the corresponding wheel is not in contact with the floor. Therefore, it will be possible to unscrew the bolts that fix the wheel to its housing and remove it completely, accessing the underlying components. Here it will be necessary to remove the bolts that fix the semi-axle joint to the wheel hub, which once moved will allow access to the headset and to remove the latter. When the headset has been removed, it will be possible to insert a new one, assembling all the removed components.
Posted on 24 December 2022 by ScegliAuto
Other guides that may interest you
|
How to reset the tire pressure warning light on Dacia Sandero?Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.024
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |