Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Punto
    4. : How do you replace the EGR valve on the Fiat Punto Evo?

Fiat Punto - Video tutorial

Model: Fiat Punto 199, Punto EVO, Grandepunto , MK 3 - Years 2005-2018
Part: Valve
Operation: How do you replace the EGR valve on the Fiat Punto Evo?

In order to replace the EGR valve on the Fiat Punto, you need to open the bonnet so that you have access to the components located inside the engine compartment. The valve will be installed between the intake manifold and the exhaust manifold, immediately forward of the engine block. After having disconnected the connectors and the various sensors, it will be possible to unscrew the bolts that fix the valve inside its housing, so that it can be replaced with a new one. This must be connected appropriately and it will therefore be possible to fix it with the relative screws.


Posted on 28 December 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Punto 1999-2011 - How much does it cost to replace the EGR valve on the Fiat Punto 1.3 multijet? Read Answer
    • Punto 2005-2018 - How to replace the EGR valve on the Fiat Grande Punto? Read Answer
    • Punto 2005-2018 - How much does it cost to replace the EGR valve on the Fiat Punto 1.3 multijet? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos