Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Cabin Fan Resistor of a Fiat Grande Punto

Model: Fiat Punto MK 3, Punto EVO, 199, Grandepunto - Years 2005-2018

Below we will see the procedure to remove and replace the cabin fan resistor of a Fiat Grande Punto. First, get inside the vehicle on the front passenger side, and start by removing the plastic cover found under the glove compartment; then disconnect the electrical connector of the cabin fan resistor, removing it from the fan as shown in the video. At this point, install the new resistor, then check the operation of the fan speed settings by following the video tutorial to the end!

Updated on 7 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Heater Fan Resistor on Fiat Grande Punto
Replacing the Heater Fan Resistor on Fiat Grande Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) Want to remove the heater fan resistor on a Fiat Grande Punto? Let's see how to disassemble the fan resistor. Remove the plastic cover from under the…
How to Replace the Fan Resistor on a Fiat Grande Punto
How to Replace the Fan Resistor on a Fiat Grande Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) How to replace the fan resistor on a Fiat Grande Punto? Here’s how to carry out the replacement. Use a lever to remove the plastic under the front wi…
How to Remove the Fan Resistor on a Fiat Grande Punto
How to Remove the Fan Resistor on a Fiat Grande Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) This video shows how to remove the ventilation resistor in the cabin of a Fiat Grande Punto. The resistor is located directly under the dashboard nea…

    Frequently Asked Questions

    • Punto 2005-2018 - Where is the inertia switch on the Fiat Grande Punto? Read answer
    • Punto 2005-2018 - How many km does the Fiat Punto run in reserve? Read answer

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos