Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Horn on the Fiat Punto

Model: Fiat Punto MK 2, 188 - Years: 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010

See other generations:
Video tutorial

In this short and simple guide, you will see the steps to remove and replace the horn on the Fiat Punto, following the instructions below. First, open the bonnet of your car and locate the horn, which is found low next to the brake fluid reservoir; then unscrew the bolt of the horn's mounting bracket, disconnecting the electrical connector to remove it, as shown in the video.

At this point, install the new horn, checking its operation before securing it to the metal bracket!


Updated on 15 July 2026 by ScegliAuto


Related tutorials

Removing the Brake Light for Fiat Punto
Removing the Brake Light for Fiat Punto
Fiat Punto (2005-2018 / 199, MK 3, Grandepunto , Punto EVO) In this video tutorial, you will learn how to remove the upper brake light of the Fiat Punto. Open the boot and remove the rubber caps by disengaging…
Where Are the Fuses Located on the Fiat Grande Punto?
Where Are the Fuses Located on the Fiat Grande Punto?
Fiat Punto (2005-2018 / 199, MK 3, Grandepunto , Punto EVO) The fuses on the Fiat Grande Punto are located within two fuse boxes installed in the vehicle: the first is inside the cabin, in the lower left part …
Removing Horn from Fiat Grande Punto
Removing Horn from Fiat Grande Punto
Fiat Punto (1999-2011 / MK 2, 188) In today's tutorial, learn how to remove the horn from a Fiat Grande Punto. First, open and lift the bonnet and remove the grille by unscrewing the s…

    Frequently Asked Questions

    • Punto 2005-2018 - Where is the inertia switch on the Fiat Grande Punto? Read answer
    • Punto 2005-2018 - How many km does the Fiat Punto run in reserve? Read answer

How to Reset the Tyre Light on a Toyota Aygo?

To reset the tyre light on a Toyota Aygo, start by locating the reset button, which is found in the glove compartment of the front passenger side. Turn on the car and ensure that the tyres are at the correct pressure. Then, press and hold the reset button for a few seconds until the tyre light either flashes or turns off, depending on the model. Release the button and wait for the reset procedure to complete. Restart your Toyota Aygo and check if the tyre light has turned off, indicating that the reset was successful.

Watch the video!


by ScegliAuto

More videos