Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Seal on a Fiat Punto

Model: Fiat Punto MK 2, 188 - Years 1999-2011

Replacing the seal on a 2011 Fiat Punto is a very simple operation that can be done independently. This video tutorial will explain how to do it. Start by removing the clips of the pistons using a star screwdriver. When performing this operation, be careful with the boot as it may give way and cause injury. After removing the pistons, use your hands to remove the old seal. Now secure the boot and then start fitting the new seal as shown in the video. Finally, reattach the pistons.

Updated on 24 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Timing Chain of the Fiat Punto 1.3 MultiJet
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) This guide outlines the main steps to remove and replace the timing chain of the Fiat Grande Punto 1.3 MultiJet, as well as the Fiat Panda and Fiat 5…
How to Replace the Antenna Base Seal on the Fiat Grande Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) To replace the antenna base seal on the Fiat Punto Evo, open the rear bonnet and remove the seal located in the tailgate, then remove the upper seal …
Fitting Roof Bars on Fiat Punto 188
Fitting Roof Bars on Fiat Punto 188
Fiat Punto (1999-2011 / MK 2, 188) If you have a Fiat Punto 188, I recommend purchasing the pre-fitted roof bar mounts for this model, like those shown in the video. This will make you…

    Frequently Asked Questions

    • Punto 2005-2018 - Where is the inertia switch on the Fiat Grande Punto? Read answer
    • Punto 2005-2018 - How many km does the Fiat Punto run in reserve? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos