Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Gear Lever Gaiter on a Fiat Panda 169

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Shift knob

Replacing the gear lever gaiter is very simple as it is all secured by clips. Start by pulling the gear lever knob upwards with force, remove the spring, and detach the frame at the base of the gaiter that secures it to the centre console. Once the gaiter frame is detached, you can pull it off. Insert the new gaiter and engage the fixing tabs of the frame at the base into their respective slots in the console. Once the gaiter is secured, insert the spring and reposition the knob, aligning it and pressing it down until it clicks into place.

Updated on 19 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Gear Gaiter on Fiat Panda
Replacing the Gear Gaiter on Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) Need to replace the gear gaiter on a Fiat Panda? Here’s how to remove the damaged gaiter from the top of the gear lever. Remove the gear knob from th…
How to Replace the Drive Shaft on a Fiat Panda 169 4x4
How to Replace the Drive Shaft on a Fiat Panda 169 4x4
Fiat Panda (2003-2012 / 169, MK 2) Discover in this video the instructions for replacing the drive shaft on a Fiat Panda 169 4x4. First, lift the vehicle and position the jack under th…
How to Replace the Thermostat on a Fiat Panda 169
Fiat Panda (2003-2012 / 169, MK 2) This video outlines all the necessary steps to replace the thermostat on a Fiat Panda 169, including how to replace the temperature sensor. By follow…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos