Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Injectors from the Fiat Grande Punto 1.3 Multijet

Model: Fiat Punto MK 3, Punto EVO, 199, Grandepunto - Years 2005-2018
Part: Fuel injectors

Below are the step-by-step instructions that will allow you to remove and replace the diesel injectors on the Fiat Grande Punto 1.3 Multijet. First, open the bonnet and start by disconnecting the mass/air sensor; then remove the upper cover and disconnect the electrical connectors from the injector rail to remove it, as shown in the video. At this point, remove the metal clip and unscrew the injector to take it out; repeat the same operation on all other injectors, replacing them with new ones if necessary.

Updated on 3 September 2026 by ScegliAuto

Video tutorial

Related tutorials

Dismantling the Injectors of the Fiat Grande Punto 1.3 MultiJet
Dismantling the Injectors of the Fiat Grande Punto 1.3 MultiJet
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) In today's video, see how to dismantle and replace the fuel injectors of the Fiat Grande Punto 1.3 MultiJet, as well as on the 500 and Panda. First, …
Instructions for Removing Injectors from a Fiat Grande Punto 1.3 MultiJet
Instructions for Removing Injectors from a Fiat Grande Punto 1.3 MultiJet
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) In this video tutorial, you will see instructions on how to remove the injectors from a Fiat Grande Punto powered by a 1.3 MultiJet engine. First, op…
Guide to Replacing the Injectors on the Fiat Punto 1.3 MultiJet
Guide to Replacing the Injectors on the Fiat Punto 1.3 MultiJet
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) In this guide, you will find instructions to remove and replace the injectors on the Fiat Punto 1.3 MultiJet. First, open the engine cover of the veh…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos