Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Malfunction of the LPG Switch on a Fiat Tipo 1.4 MultiPower

Model: Fiat Tipo 356, 357, 358 - Years 2016-2026
Part: Checks and maintenance

This video explains the possible reason for the failure to switch a Fiat Tipo 1.4 with a MultiPower engine from petrol to LPG. The system is installed directly by the manufacturer, so any issues related to incorrect installation of components during assembly can be ruled out. In diagnostics, the OBDII shows error P0193 "ECU 10 Pressure Sensor A in the injection rail", so to remedy the issue, it was necessary to replace the pressure sensor, as indicated by the YouTuber in the video. After this replacement, the vehicle resumed normal operation, which is something to keep in mind if you encounter a similar issue.

Updated on 13 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Gas Filter on a Fiat Tipo
How to Replace the Gas Filter on a Fiat Tipo
Fiat Tipo (2016-2026 / 356, 357, 358) As shown in the video, to replace the LPG filter on a Fiat Tipo, first obtain a new filter and remove the old one with the vehicle turned off and col…
Problems that can cause worn out spark plugs on a Fiat Tipo with LPG.
Problems that can cause worn out spark plugs on a Fiat Tipo with LPG.
Fiat Tipo (1988-2000 / MK 1) As the YouTuber tells us, spark plugs on LPG cars tend to last less than those on gasoline cars, because LPG burns at higher temperatures than gasoli…
How to deactivate the lane assist of the Fiat Tipo
How to deactivate the lane assist of the Fiat Tipo
Fiat Tipo (2016-2026 / 356, 357, 358) In the following article, we will see how to deactivate the lane assist or lane control of the Fiat Tipo. To perform this procedure, only a few secon…

    Frequently Asked Questions

    • Fiat Tipo 2016-2026 - The Start and Stop system no longer works on my Fiat Tipo, what could it be? Read answer

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos