Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : How to remove the rear turn signal bulb of the Fiat 500 Abarth

Fiat 500 - Video tutorial

Model: Fiat 500 312 - Years 2007-2023
Part: Rear light bulb
Operation: How to remove the rear turn signal bulb of the Fiat 500 Abarth

Below we will see the instructions that will allow us to disassemble and replace the turn signal bulb of the rear taillight of the Fiat 500 Abarth. First, we open the rear trunk door and start unscrewing the two fixing screws next to the rear taillight; then we disconnect the electrical connector of the bulbs to remove it, as shown in the video. At this point, we separate the light fixture from the bulb holder and remove the turn signal bulb, replacing it with the new one (having the same connection); finally, we reassemble the rear taillight!


Posted on 29 April 2024 by ScegliAuto

    Frequently Asked Questions

    • 500 2007-2022 - Why is the brake light of the Fiat 500 not working? Read Answer
    • 500 2007-2021 - Why are the brake lights of the Fiat 500 not working? Read Answer
    • 500 2007-2021 - Which taillights does the Fiat 500 mount? Read Answer
    • 500 2014-2022 - How to replace rear light bulbs in Fiat 500X? Read Answer
    • 500 2007-2023 - How many reversing lights are there on the Fiat 500? Read Answer
    • 500 2014-2022 - How many reversing lights does the Fiat 500X have? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos