Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace Rear Suspension on Ford Transit MK6

Model: Ford Transit MK 6 - Years 2000-2006
Part: Suspension system

In this short video, you will see how to remove and replace the rear suspension on a Ford Transit MK6, following the instructions below. First, lift the vehicle and start by removing the rear wheel; then unscrew the upper mounting bolt of the suspension with two spanners, thus removing the pin. At this point, remove the lower bolt as well as the pin, taking out the suspension and replacing it with the new one; perform the same operation on the other side: it is important to tighten the bolts (upper and lower) to the correct torque!

Updated on 17 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Light Bulbs on a Ford Transit
How to Replace the Rear Light Bulbs on a Ford Transit
Ford Transit (2000-2006 / MK 6) In this tutorial, you will learn how to remove and replace the rear light bulbs and the entire rear lamp on a Ford Transit. First, open the rear door…
How to Remove the Rear Seats from a Ford Transit Connect
How to Remove the Rear Seats from a Ford Transit Connect
Ford Transit (2014-2024 / MK 8) Below are the main instructions to help you remove the rear seats from a Ford Transit Connect by following these simple steps. First, open the rear d…
How to Remove the Rear Seats from a Ford Transit
How to Remove the Rear Seats from a Ford Transit
Ford Transit (2014-2024 / MK 8) In this brief guide, we will see the instructions that will allow us to disassemble and remove the rear seats from the Ford Transit. First, get insid…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos