Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Rear Brake Shoes on the Ford Fiesta MK6

Model: Ford Fiesta Fiesta 5, MK 5, MK V - Years 2002-2008
Part: Brake pads

Today, we will go through the main steps to remove and replace the rear brake shoes on the sixth-generation Ford Fiesta. First, lift the vehicle at the rear and start by removing the wheel; then, remove the rear drum by unscrewing the rear mounting screws with a 17 mm and 8 mm spanner, as shown in the video. Next, remove the retainers and springs from the shoes; then clean away any residual dirt and fit the new shoes of the correct type. Apply the reverse procedure for reassembly!

Updated on 25 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Rear Brake Shoes on a Ford Fiesta MK7
Replacing the Rear Brake Shoes on a Ford Fiesta MK7
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) This video will show the main instructions for removing and replacing the rear brake shoes on the seventh generation Ford Fiesta. First, lift the veh…
How to Replace the Rear Brake Shoes on a Ford Fiesta?
How to Replace the Rear Brake Shoes on a Ford Fiesta?
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) To replace the rear brake shoes on a Ford Fiesta, lift the car using a jack or ramp, so that the corresponding wheel is not in contact with the groun…
How to adjust the handbrake of the Ford Fiesta from the rear brake shoes
How to adjust the handbrake of the Ford Fiesta from the rear brake shoes
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) On some occasions, it is possible to adjust the handbrake of the Ford Fiesta from the rear brake shoes, after making the main adjustment from the cen…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos