Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : How to replace the front bulbs of the Ford Focus

Ford Focus - Video tutorial

Model: Ford Focus MK 3 - Years 2011-2018
Part: Headlight
Operation: How to replace the front bulbs of the Ford Focus

In this video we will see how to replace the front bulbs of the third series Ford Focus. First, leave the car turned off for some time to have a smoother job. Then start by placing the car on a level surface, pulling the handbrake. Now open the hood and proceed. With a Phillips screwdriver remove the screws that hold the headlight in place and disassemble it. Now you can work smoothly by removing the rubber cover and then unplugging the power connector. Now let's take out the old light bulb. For the low beam you will need an H7. We proceed in the same way for the other bulbs.


Posted on 27 March 2024 by ScegliAuto

    Frequently Asked Questions

    • Focus 2011-2018 - What causes the Ford Focus low beam headlight problem? Read Answer
    • Focus 2004-2011 - How much does it cost to replace the Ford Focus Mk2 low beam bulb? Read Answer
    • Focus 2018-2025 - How to reset errors and fault codes of a Ford Focus 2018? Read Answer
    • Focus 1998-2004 - How to remove the alternator belt of a Ford Focus? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos