Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Oil and Oil Filter Change on a Ford Connect

Model: Ford Connect MK 2 - Years 2013-2023
Part: Engine oil

Lift the bonnet but start working underneath the engine bay (if you struggle, raise the vehicle with a jack). Unscrew all the Torx screws securing the lower protection panel and remove it. Unscrew the oil filler cap and go underneath the vehicle to unscrew the bolt that seals the oil drain hole, collecting the oil in a container. While the oil drains, unscrew and replace the filter as shown in the video (before inserting the new filter, lubricate the seal slightly). Close the drain hole and refill with new oil from the top.

Updated on 5 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Service Light on a Ford Connect
How to Reset the Service Light on a Ford Connect
Ford Connect (2002-2013 / MK 1) In this video, you will see how to reset the service light on a Ford Connect MK1: naturally, after changing the oil and filter, and properly disposin…
How to reset the oil light on the 2014 Ford Connect
How to reset the oil light on the 2014 Ford Connect
Ford Connect (2013-2023 / MK 2) Resetting the oil light on the 2014 Ford Connect after an oil change is a very simple operation that can be done in a few minutes. The first step is …
How to Reset the Oil Change Light on the Ford Connect
How to Reset the Oil Change Light on the Ford Connect
Ford Connect (2013-2023 / MK 2) In this article, you will see the procedure to reset the oil change light, or service light, on the Ford Connect. To reset the light, start the instr…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos