Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Ford
  4. :
  5. Focus
  6. : How to disassemble and clean the fuel injectors of the Ford Focus ST

Ford Focus - Video tutorial

Model: Ford Focus MK 3 - Years 2011-2018
Part: Injectors
Operation: How to disassemble and clean the fuel injectors of the Ford Focus ST

In this video tutorial we will see how to disassemble and clean the fuel injectors of the Ford Focus ST. First of all we open the bonnet and start by removing the intake ducts; to do this we disconnect the various electrical connectors that we find above, unscrewing the fixing screws of the duct, as shown in the video. Once the intake part has been removed, we can remove the injector rail; we use a star wrench to remove the injectors. Now we carry out the cleaning of the same or we opt directly for the replacement.


Posted on 7 April 2024 by ScegliAuto

    Frequently Asked Questions

    • Focus 2011-2018 - How much do the Ford Focus 1.6 TDCi injectors cost? Read Answer
    • Focus 2004-2011 - What problems do Ford Focus injectors have? Read Answer
    • Focus 1998-2004 - Does the Ford Focus 1.6 TDCi have problems with the injectors? Read Answer
    • Focus 2004-2011 - How to replace the injectors in a diesel-powered Ford Focus? Read Answer
    • Focus 2004-2011 - How much do Ford Focus diesel injectors cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos