Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Mustang
    4. : How to replace the petrol filter

Ford Mustang - Video tutorial

Model: Ford Mustang MK 4 - Years 1994-2004
Part: Petrol filter
Operation: How to replace the petrol filter

To change the fuel filter you must first lift the car on a bridge or with a jack. Once you have located the filter, start by unhooking the clips on both sides of the filter. Now equip yourself with the special tool in the shape of a plastic ring to remove the fuel pipes. Pay attention to the possible spillage of petrol residues from the filter. Once the pipes have been released, you can unscrew the screw clamp and finally release the filter. Always check that the spare part is exactly the same as the original that you have just disassembled. Then fasten the new filter with the screw clamp. Insert the tubes one on each side until you hear a click and then replace the clips. Car Model: Ford Mustang Year: 1994-2004 Tools Required: Ring nut tool to release the fuel lines


Posted on 28 July 2023 by ScegliAuto



How to replace the air filter on Ford Mustang Gt
Ford Mustang (2015-2023 / MK 6, S550) To be able to replace the air filter on the car it is necessary to proceed as follows: open the bonnet, on the right side near the optical unit, ther
Cabin air filter replacement
Ford Mustang (2005-2014 / MK 5, S197) The seat for the passenger compartment air filter is located in the engine compartment, on the passenger side, immediately under the windscreen, near
Replacing the oil and its filter
Ford Mustang (2005-2014 / MK 5, S197) In the following tutorial the filter is replaced and the oil is changed on a Ford Mustang. Unscrew the oil pan cap located under the car with an eye

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos