Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Cabin Fan Motor on a Ford Escape

Model: Ford Escape MK 2 - Years 2008-2012
Part: Blower motor

Discover in this brief guide how to remove and replace, in simple steps, the cabin fan motor on a Ford Escape. First, open the front door on the passenger side and locate the cabin fan, which is situated under the glove compartment. Then, disconnect its electrical connector and unclip the two plastic tabs to remove the cabin fan, as shown in the video. At this point, install the new cabin fan in the correct orientation, connecting the electrical connector!

Updated on 21 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Where are the fuses located in the Ford Escape?
Where are the fuses located in the Ford Escape?
Ford Escape (2001-2007 / MK 1) The fuses in the Ford Escape are divided among the dedicated fuse boxes located within the vehicle. This model has two: one is inside the cabin, behi…
Replacement of the heating resistor of a Ford Escape
Replacement of the heating resistor of a Ford Escape
Ford Escape (2008-2012 / MK 2) We can see in this very short tutorial how to replace the cabin fan resistor on a Ford Escape, second generation model produced from 2008 to 2012. Fi…
Replacing the Cabin Air Filter on the Ford Escape
Replacing the Cabin Air Filter on the Ford Escape
Ford Escape (2008-2012 / MK 2) In today's video, we will see how to remove and replace the cabin air filter on the Ford Escape, following the instructions below. First, open the ho…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos