Do it yourself
Frequently asked questions about cars and motorcycles

Replacing the Car Battery

Model: Ford Mondeo / Fusion MK 1 - Years 1993-2000
Part: Battery

If, after charging, there are no positive results, it means the battery needs to be replaced. This operation is quite simple if you follow the correct steps. Once you have obtained the new battery, check the manual of your car for the correct amperage and voltage. Loosen the negative terminal, marked with a -, and then do the same with the positive terminal, marked with a +. Unscrew the support screws of the battery holder to proceed with the replacement.

Updated on 12 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Ford Mondeo / Fusion (2007-2014 / MK 3) Open the bonnet and remove the plastic cover on the engine; disconnect the air mass meter connector, the clamp securing the intake duct, and remove t…
Ford Mondeo / Fusion (2022-2026 / MK 5) In today's video, you will see how to reset the BMS, or Battery Monitoring System, on a Ford Mondeo, fifth generation model produced from 2022 onward…
Ford Mondeo / Fusion (2007-2014 / MK 3) In this video tutorial, you will see the necessary instructions to reset the immobiliser and start the vehicle on the third series Ford Mondeo in sim…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos