Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove and Install the Rear View Mirror on a 2020 Ford Transit

Model: Ford Transit MK 8 - Years 2014-2024
Part: Rearview mirror

The first step for installing a new internal rear view mirror on a 2020 Ford Transit is to remove the plastic cover. To do this, insert a spudger, a plastic tool similar to a spatula, into the seam between the two pieces and lever it off; as they are clipped together, removal should be quite straightforward. Once the plastic housing is removed, the next step is to rotate the arm of the internal mirror by 45 degrees, which will allow it to be removed. When performing these steps, be very careful not to damage the windscreen. At this point, take a new mirror or repair the old one and refit it by reversing the process. If you do not want to change the rear view mirror because upon removal you realised that the issue is not the mirror but the screws, simply tighten them and reattach the old mirror.

Updated on 15 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Where Are the Fuses on a Ford Transit?
Where Are the Fuses on a Ford Transit?
Ford Transit (2014-2024 / MK 8) Each fuse on the Ford Transit regulates the operation of a device installed within the vehicle: there are two fuse boxes inside the cabin and one in …
How to Replace the Starter Motor on the Ford Transit?
How to Replace the Starter Motor on the Ford Transit?
Ford Transit (2006-2014 / MK 7) To replace the starter motor on the Ford Transit, access the lower part of the engine bay: here, immediately next to the oil tank, you will find the …
How do you remove the front seat of the Ford Transit?
How do you remove the front seat of the Ford Transit?
Ford Transit (2014-2024 / MK 8) In order to remove the front seat of the Ford Transit, you need to loosen the screws that hold it in place from the bottom, both in the front and in …

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos