Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : Guide to replacing the headlight

Ford Focus - Video tutorial

Model: Ford Focus MK 1 - Years 1998-2004
Part: Headlight
Operation: Guide to replacing the headlight

The tools needed are a Phillips screwdriver, a slotted screwdriver and a 10mm wrench. To remove the headlight you must first remove the protective mask above the front grille by unscrewing the screws present, after which remove the screws that hold the front grille in place, two on each side, remove the bulbs and set the grille aside. The lights are fixed on three points, remove the screws and remove the headlight after disconnecting the cables. Now you can conveniently change the burnt out lamp. The video is very comprehensive and just follow it carefully for more details. The guide is for a 2002 Ford Focus 3-door.


Posted on 22 June 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Focus 2011-2018 - What causes the Ford Focus low beam headlight problem? Read Answer
    • Focus 2004-2011 - How much does it cost to replace the Ford Focus Mk2 low beam bulb? Read Answer
    • Focus 2018-2025 - How to reset errors and fault codes of a Ford Focus 2018? Read Answer
    • Focus 1998-2004 - How to remove the alternator belt of a Ford Focus? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos