Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : Replace the Ford Focus headlight bulbs

Ford Focus - Video tutorial

Model: Ford Focus MK 2, Focus 2 - Years 2004-2011
Part: Headlight
Operation: Replace the Ford Focus headlight bulbs

Are the headlight bulbs on Ford Focus burned out? Let's see the replacement. We open the front hood by pulling the lever located at the bottom right of the dashboard, let's put it in safety with the rod. We unscrew the tightening screws above the headlight. We remove the inspection cap of the lighthouse (located in the rear part of the lighthouse). We disassemble the lamp holders from the headlight and we go to extract the damaged bulbs with the help of a screwdriver. We always install new bulbs of the same type and size as the old ones. We insert the lamp holder in the lighthouse housing. We close the headlight with plastic cover caps. We mount the headlight.


Posted on 3 December 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Focus 2011-2018 - What causes the Ford Focus low beam headlight problem? Read Answer
    • Focus 2004-2011 - How much does it cost to replace the Ford Focus Mk2 low beam bulb? Read Answer
    • Focus 2018-2025 - How to reset errors and fault codes of a Ford Focus 2018? Read Answer
    • Focus 1998-2004 - How to remove the alternator belt of a Ford Focus? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos