Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Front Headlamp on a Ford Focus MK1

Model: Ford Focus MK 1 - Years: 1998, 1999, 2000, 2001, 2002, 2003, 2004
Part: Headlight

See other generations:
Video tutorial

In this video, we will see how to replace the front headlamp on the Ford Focus MK1: open the bonnet. To remove the headlamp, you need to take off the bracket that holds the headlight assembly to the body, which is secured with a bolt; there are also two clips on the sides.

The video shows these poorly because the replaced headlamp was severely damaged, so we only see the bolts attached to fragments of plastic, but afterwards, it will be sufficient to disconnect the electrical connector that powers the headlamp from the rear.

To fit the new headlamp, however, you will also need to remove the small grille at the front of the vehicle.

Therefore, proceed from the top, removing the metal strip that covers the bonnet latch, then the grille (there are only a few screws, as seen in the video). At this point, you will have enough space to insert the new headlamp, which can be found, for example, on tarostrade.it for £73.92 + £7.00 for delivery.

Secure the headlamp to its two mounts, replace the grille and metal strip, and reattach the bracket that secures the headlight assembly to the body. Job done.


Updated on 14 September 2026 by ScegliAuto


Related tutorials

Ford Focus (2004-2011 / MK 2, Focus 2) Want to remove the front headlight from the Ford Focus? The headlight is secured with retaining screws, so let’s see how to do it. Unscrew the retain…
Ford Focus (2011-2018 / MK 3) Before starting, open the bonnet of your Ford Focus. Begin by unscrewing and removing the screws that secure the front headlamp to the car's frame. N…
Ford Focus (1998-2004 / MK 1) The following steps will show you how to remove and replace the front headlamp on the Ford Focus, following the instructions below. First, open the b…

Other guides you may be interested in

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos