Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Carburettor from the 1975 Garelli Flex

Model: Garelli Flex
Part: Carburetor

Video tutorial

In this video tutorial, you will learn how to remove the carburettor from the 1975 Garelli Flex 50cc, following the instructions below. First, remove the air filter by undoing the securing screw that holds it to the carburettor; then, turn off the fuel tap and disconnect the throttle cable, as shown in the video.

At this point, disconnect the fuel pipe and undo the screw of the carburettor clamp to remove it; all that’s left is to carry out the inspection and cleaning, following the video to the end!


Updated on 9 May 2026 by ScegliAuto


Related tutorials

How to Remove and Replace the Carburettor on a Garelli 50
How to Remove and Replace the Carburettor on a Garelli 50
In this guide, we will provide instructions to remove and replace the carburettor on a Garelli 50. First, place it on the centre stand and start by d…
How to replace the variator oil of a Garelli Eureka Flex?
How to replace the variator oil of a Garelli Eureka Flex?
Eureka Flex To replace the variator oil in your Garelli Eureka Flex, ensure the engine is cold. Lift the motorcycle onto a stand. Remove the oil tank cap and the…
How to Clean the Carburettor on the Garelli
How to Clean the Carburettor on the Garelli
In this short video, see the steps to clean the carburettor on your Garelli 50cc, as well as on the Piaggio Si, Ciao, and Bravo. First, remove the ca…

How to Replace the Air Filter in a Moto Guzzi Nevada 750?

In this tutorial, you will see how to replace the air filter in a Moto Guzzi Nevada 750, a very simple and quick operation. First, wait for the engine to be completely cold, then remove the seat, disassemble the chrome air intake, and subsequently the panel located under the tank. Repeat the operation on the opposite side, disconnect both the fuel hoses and the pump connector, and remove the tank itself. At this point, you can move all the cables above the airbox, open it, and remove the old filter. To install the replacement and reassemble everything, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos