|
Do it yourself
| |||
| ||||
Dismantling the Carburettor on a Gasgas EC 250
Model: Gasgas Ec 250
Video tutorial
In this tutorial, we will go through the steps to dismantle the carburettor on a Gasgas EC 250 enduro bike, following the instructions below. First, close the fuel tap to prevent petrol leaks; then disconnect the air filter box from the carburettor by loosening the clamp screw. Next, disconnect all the carburettor hoses and detach it from the cylinder intake; finally, disconnect the throttle cable to remove it completely, following the video to the end!
Updated on 10 April 2026 by ScegliAuto
Related tutorials
Ec 250
The procedure for dismantling the engine of the GasGas EC 250 involves loosening all the bolts that secure it to the appropriate supports, allowing i…
Ec 250
To replace the starter motor on the GasGas EC 250, locate its housing on the left side of the bike, just above the clutch cover. The part can be remo…
Ec 250
To replace the front shocks on the GasGas EC 250, loosen the bolts that secure the front wheel to the lower part of the fork. Once these bolts are lo…
|
How to replace the engine oil and oil filter on a Moto Guzzi V7 Stone
Let’s discover the steps to perform routine maintenance by replacing the engine oil and oil filter on the Moto Guzzi V7 Stone. First, place the motorcycle on its stand and begin to unscrew the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; clean or replace the metal oil filter as shown in the video. At this point, unscrew the oil filler cap and top up the oil; check the level from the side window! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.008
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
