Do it yourself
Frequently asked questions about cars and motorcycles

Model: Gasgas Ec 300

In this video, we will see how to remove and replace the crankshaft oil seal on a Gasgas EC 300 enduro bike, following the instructions below. First, drain the engine oil from your bike and then disconnect the radiator fluid hose, allowing it to drain; next, proceed to remove the clutch by unscrewing the screws of the cover and the clutch itself, removing the discs. At this point, once the bell is removed, you can take off the crankshaft washers and gently replace the oil seal!

Updated on 10 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Ec 300 In this video tutorial, you will learn how to dismantle and replace the crankshaft oil seal on a Gasgas EC 300. First, remove the cover/protection of…
Ec 300 To replace the crankshaft bearings on the GasGas EC 300, you need to remove the engine from its housing by unscrewing the bolts that secure it to the…
Ec 300 In today's video, we will see the main steps to remove and replace the rear wheel bearing on the Gasgas EC 300 enduro bike, as well as the 250. First…

How do you reset the Oil Check light on the Sym VF 185?

In order to reset the Oil Check light on the Sym VF 185, you need to turn on the instrument panel by turning the key in the ignition switch. Once the panel is on, you can press and hold the button located at the bottom right of the instrument panel for a few seconds. You will need to continue holding the button for a few seconds and then release it before pressing the next button. This will make the Oil Check light disappear from the instrument panel, and you can turn it off again by turning the key in the opposite direction.

Watch the video!


by ScegliAuto

More videos