Do it yourself
Frequently asked questions about cars and motorcycles
To install the new rubber strap of the stand, first remove the old one: it is located on the left side of the bike, corresponding to the end of the seat. This strap is connected via a bolt with a nut. By loosening the bolt, you can remove the old strap and insert the new one. To insert it, bend the upper flap of the strap so that it can be secured between the nut and the plastic side panel of the bike. After securing the flap, tighten the bolt so that the strap remains fixed and holds the stand.

Updated on 21 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Ec 300 In this tutorial video, you will learn how to remove and replace the front headlight bulb on a GasGas EC 300. First, obtain the new bulb and remove t…
Ec 300 This guide provides the main instructions on how to remove and replace the radiator thermostat on the Gasgas EC 300 enduro bike. First, place your bi…
Ec 300 Today, you will learn how to remove and replace the carburettor on a Gasgas EC 300 enduro bike by following these simple steps. First, place your bik…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos