Do it yourself
Frequently asked questions about cars and motorcycles

How to Start a Gas Gas TXT 125

Model: Gasgas Txt 125
Part: Checks and maintenance

Video tutorial

Before you can start, mount your Gas Gas TXT 125. Begin by inserting and turning the key in the ignition switch. Next, open the engine start lever located at the bottom left of the engine block.

Once done, pull and hold the clutch lever while quickly pressing the engine start lever multiple times until the engine starts. Once the engine is running, you can release the clutch lever and close the start lever, completing the procedure.


Updated on 22 April 2026 by ScegliAuto


Related tutorials

Txt 125 To replace the exhaust on the GasGas TXT 125, loosen the screws that secure it to the corresponding supports located on the side of the bike: the scr…
Txt 125 To replace the clutch on a GasGas TXT 125, loosen the screws securing the cover on the right side of the engine: this will allow you to remove the co…
Txt 125 You can replace the exhaust on the GasGas TXT 125 by loosening the screws that secure the exhaust end can to the appropriate supports: these are loca…

How to Replace the Engine Oil and Oil Filter of an Aprilia Tuono V4

In this guide, we will see the instructions on how to carry out the routine maintenance service by replacing the engine oil and oil filter of the Aprilia Tuono V4 motorcycle. First, place the bike on the stand and start unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge, replacing it with a new one (screwing by hand and tightening gently), as shown in the video. At this point, top up with new engine oil, bringing the level to the maximum mark.

Watch the video!


by ScegliAuto

More videos