|
Do it yourself
| |||
| ||||
How to Remove the Sprocket and Crown of the Gilera GP 800
Model: Gilera Gp 800
Video tutorial
Here are the instructions to remove and replace the sprocket and crown on the Gilera GP 800 scooter. First, place your scooter on the centre stand and begin by removing the rear wheel; to do this, unscrew the central wheel bolt, disconnect the drive chain, and loosen the swingarm bolts, as shown in the video. Next, unscrew the bolts of the wheel crown, remove it, and replace it with the new one; then, remove and replace the sprocket, following the video tutorial to the end!
Updated on 13 September 2026 by ScegliAuto
Related tutorials
Gp 800
To replace the sprocket on the Gilera GP 800, access the right side of the engine block: here, you will find the protective cover, which must be remo…
Gp 800
Today we will look at the instructions that will allow us to remove and replace the variator of the Gilera GP 800 scooter in simple and quick steps. …
Gp 800
To remove the rear wheel of the Gilera GP 800, you need to loosen the side bolts that secure the central axle of the wheel to the end of the swingarm…
|
How to Replace the Coolant in the KTM XC 300
Follow this guide on how to replace the coolant in the KTM XC 300 enduro bike, as well as the XC-W 300. First, place your bike on a stand and start by unscrewing the coolant drain screw located at the bottom of the water pump casing, allowing it to drain into a container for about ten minutes; then unscrew the radiator cap as shown in the video. At this point, top up with new coolant suitable for your radiator, filling to the maximum level mark! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.007
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |