Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Honda Sh 150
Part:

To replace the rollers of a Honda SH 150 variator, you need to remove all the bolts and fixing screws of the cover located on the left side of the bike, corresponding to the rear wheel. Once the cover is open, you can loosen the nut that secures the variator shaft and also remove the clutch bell. By removing both the variator and the bell, the belt will also be easily extractable. This should be reinserted between the new variator and the clutch when the new parts are installed. Finally, close and secure the cover again.

Updated on 20 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Variator on a Honda SH 150
How to Replace the Variator on a Honda SH 150
Sh 150 In this brief guide, you will find the main instructions to disassemble and replace the variator on the Honda SH 150 scooter. First, place the scoote…
Replacement of the rollers and belt of the Honda SH 150
Replacement of the rollers and belt of the Honda SH 150
Sh 150 Today's video will show us how to disassemble and replace the belt and rollers of the Honda SH 300 scooter. First, we put the scooter on the center s…
How to Service a Honda SH 150
How to Service a Honda SH 150
Sh 150 To service the Honda SH 150, first replace the air filter. To access it, remove the bolts securing the cover above the gearbox. Once the cover is rem…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos