Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Honda
    3. :
  3. Forza
    4. : How to install heated grips in Honda Forza

Model: Honda Forza
Part:
How to install heated grips in Honda Forza

In today's video we see how to install heated grips in the Honda Forza. First we proceed by purchasing the specific component in the main online spare parts sites or in physical stores. We then proceed by removing the original grips from our bike. Once this is done, we insert the new units in the same locations. We then proceed to create the connections, using the services battery. We then install the ignition lock of the grips in the handlebar of the motorcycle. Once this is done, we test the correct functioning. If everything ok, we can finish the current work.


Posted on 6 December 2022 by ScegliAuto



To reset the service light on the Honda Forza.
Forza If the service light on your Honda Forza dashboard stays on even after the service has been performed, don't worry because you can easily reset it ma
How to reset the Honda Forza service light
Forza To be able to manually reset the service light of your Honda Forza it takes a few simple steps that we will discover in our new mini guide. First mak
How to replace the battery of the Honda Forza 300?
Forza In order to replace the battery of the Honda Forza 300 you need to lift the saddle and loosen the bolts that are located at the joint that joins the

How to change the Royal Enfield Himalayan engine oil and filter

The guide shows you how to change the Royal Enfield Himalayan engine oil and oil filter. The first operation to perform is to secure the vehicle and turn it on to make the oil fluid. At this point, after having placed protection against splashes under the bleed valve and having prepared a container for the disposal of used oil, with a 22 mm wrench, open the valve. Using an 8 mm wrench, remove the fixing bolts of the inspection hatch of the mesh filter and extract the latter. Refit the clean filter and close the door; install the gasket on the purge valve and tighten it in place. On the opposite side of the vehicle, unscrew the three 8 mm bolts and drain the oil from the filter. Remove the old cartridge and clean the housing. Pour some oil into the new cartridge to facilitate the circulation of the oil. Put everything back in place. Fill the tank to the correct level and run the engine for a few minutes. Check the level again and top up if necessary.

Watch the video!


by ScegliAuto

More videos