Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Honda
    3. : Transalp 650

Honda Transalp 650 - Video guides

Honda Transalp 650
How to replace the rear brake pads on the Honda Transalp 650?
To replace the rear brake pads on the Honda Transalp 650, loosen the bolts that secure the caliper to the corresponding disc: once the bolts are loosened, …Read all…
Posted on 1 September 2026 by ScegliAuto
Honda Transalp 650
How to restart a motorcycle with a dead battery.
In this video, we can see how to start a motorcycle that has already experienced the cold problem and therefore has a dead battery. In this case, it is a Honda …Read all…
Posted on 8 January 2026 by ScegliAuto
Honda Transalp 650
How to Replace the Headlight Bulb of a Honda Transalp 650?
To replace the headlight bulb of the Honda Transalp 650, loosen the screws securing the trim around the headlight: these screws are located just above the fork …Read all…
Posted on 21 September 2026 by ScegliAuto
Honda Transalp 650
Replacing the Headlight Bulb on the Honda Transalp
This brief guide outlines the steps to remove and replace the headlight bulb on the Honda Transalp motorcycle, following the instructions below. First, place …Read all…
Posted on 17 July 2026 by ScegliAuto
Honda Transalp 650
How to Replace the Fork Gaiters on the Honda Transalp 650
This guide explains the procedure for replacing the fork gaiters on the Honda Transalp 650. The tools required for this job are: hex or star screwdriver, …Read all…
Posted on 5 September 2026 by ScegliAuto

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos