Do it yourself
Frequently asked questions about cars and motorcycles

How to perform a service on your own Honda Civic EJ9 (MK7)

Model: Honda Civic MK 7 - Years 2001-2006
Part: Engine oil

To change the oil and filter on a Honda Civic MK7, you will need just under 4 litres of 10W140 semi-synthetic oil and a filter that can be found on Amazon with code B004ZK2BL2 for £5.90, with free delivery. Heat the oil for 5 minutes, lift the front of the vehicle and place it on axle stands. After opening the filler cap, drain the old oil into a large container: dispose of it along with the old filter at an authorised centre. While it drains, replace the filter: remove the old one and fit the new one, lubricating the seal with a bit of clean oil. Screw the filter on by hand, then tighten without forcing. Once the oil has drained, replace the cap and seal and close it. Lower the car and pour approximately 3.5 litres of oil into the filler neck: start the engine for 30 seconds, wait 2 minutes to allow the filter to fill, and check the dipstick. Top up until the level is between minimum and maximum (up to 3.8 litres total). Check for leaks and close the bonnet.

Posted on 17 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Honda Civic (2001-2006 / MK 7) Before starting, open the front door of your Ford Fiesta. Begin by prising out and removing the inserts from the door panel. Next, unscrew and remove…
Honda Civic (2001-2006 / MK 7) Before you can start, sit in the driver's seat of your Honda Civic. Start by unclipping and removing the covers of the sun visor support brackets. Th…
Honda Civic (2001-2006 / MK 7) The steps for changing the clock on the instrument panel and radio of a 2002 Honda Civic are very simple and quick to do independently. To adjust the…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos