Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Today, follow these instructions to remove and replace the clutch cable on the Husqvarna Svartpilen 401 motorcycle, as well as the Vitpilen. First, place the motorcycle on a stand and disconnect the clutch cable from the lever by loosening the adjuster; then disconnect the cable from the lower part, on the clutch cover, removing and replacing the cable along with the sheath, as shown in the video. At this point, install the new clutch cable, then adjust it at the lever using the adjuster screw, following the video tutorial to the end!

Updated on 9 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Air Filter on a Husqvarna Svartpilen 401
How to Replace the Air Filter on a Husqvarna Svartpilen 401
Svartpilen 401 To replace the air filter on a Husqvarna Svartpilen 401, insert the ignition key into the lock located on the left side of the bike to release the se…
How to Replace the Air Filter on the Husqvarna Svartpilen 401
How to Replace the Air Filter on the Husqvarna Svartpilen 401
Svartpilen 401 These brief and simple steps will show you how to remove and replace the engine air filter on the Husqvarna Svartpilen 401, as well as the Vitpilen 4…
How do you replace the chain of the Husqvarna Svartpilen 401?
How do you replace the chain of the Husqvarna Svartpilen 401?
Svartpilen 401 To replace the chain of the Husqvarna Svartpilen 401, you will need to break the piece using a chain breaker: this way, it will be possible to split …

How to change the coolant of a Benelli 302S?

To change the coolant of a Benelli 302s, it is important to follow some key steps. Start by placing the motorcycle on a flat surface and wait for the engine to cool completely. Find the coolant tank cap, located on the left side of the motorcycle. Remove the cap carefully to allow the pressure to release and to check the coolant level. If the level is low, proceed with the change. Find the radiator drain plug, located at the bottom of the radiator, and place a collection container underneath it. Unscrew the drain plug carefully and let the coolant drain completely into the container. Once drained, screw the drain plug back in. Now, you can fill the tank with new coolant, being careful not to exceed the maximum level indicated. Finally, screw the tank cap back on and make sure it is securely tightened. Once completed, the replacement will be finished.

Watch the video!


by ScegliAuto

More videos