Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Rear Bumper Replacement for Jeep Renegade

Model: Jeep Renegade MK 1, BU, 520 - Years: 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025
Part: Rear bumper

Video tutorial

Open the boot and remove the T30 Torx screws that secure the bumper to the boot. Next, move to the underside of the vehicle where you will find four more screws securing the rear bumper from below.

If you find it difficult to work with the car on the ground, lift it with a jack. The screws located under the bumper are also T30 Torx. At this point, detach the bumper from its position a little at a time.

Perform this operation carefully to avoid damaging the frame clips. Fit the new bumper by screwing in all the bolts that were removed; you can choose to start with the upper or lower screws.


Updated on 31 March 2026 by ScegliAuto


Related tutorials

Instructions for Removing the Rear Bumper on Jeep Renegade
Instructions for Removing the Rear Bumper on Jeep Renegade
Jeep Renegade (2014-2026 / MK 1, BU, 520) In this tutorial, you will find instructions to remove the rear bumper of a Jeep Renegade. First, open the boot lid and remove the rear lights by uns…
How to disassemble the grille and front bumper of the Jeep Renegade
How to disassemble the grille and front bumper of the Jeep Renegade
Jeep Renegade (2014-2026 / MK 1, BU, 520) In this guide, we will see the steps useful for disassembling and replacing the grille and front bumper of the Jeep Renegade. First of all, we open t…
How to Replace the Fog Light Bulb on a Jeep Renegade
How to Replace the Fog Light Bulb on a Jeep Renegade
Jeep Renegade (2014-2026 / MK 1, BU, 520) In this video, learn how to replace the fog light bulb on a Jeep Renegade. Start by using a suitable screwdriver to remove the plastic cover located …

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos