Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Engine Oil Replacement on Jeep Compass

Model: Jeep Compass MK 49, MK 1 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016
Part: Engine oil

See other generations:
Video tutorial

In this video, you can see how to replace the engine oil when the message to change the engine oil appears on your Jeep Compass. When this message appears, it means that the engine oil in your vehicle needs to be replaced.

First, lift the bonnet and open the engine oil cap; position your vehicle on a column lift to raise it, or use a jack. Take a socket spanner to unscrew the bolt from the oil sump; allow all the oil to drain into a waste disposal container.

Once all the engine oil has drained, securely close the bolt of the oil sump. Lower the vehicle back to the ground, lift the bonnet, and top up the oil (use 5W-30 oil) for a Compass 2.0 CRD engine; approximately 4 litres will be needed.

Tighten the engine oil cap securely.


Updated on 24 May 2026 by ScegliAuto


Related tutorials

How to Reset the Oil Warning Light on a 2021 Jeep Compass
Jeep Compass (2016-2025 / 552, MK 2) The manual reset of the engine oil warning light on the dashboard of your 2021 Jeep Compass is very straightforward. In this mini guide, you will dis…
How to reset the oil light on a 2011 Jeep Compass
How to reset the oil light on a 2011 Jeep Compass
Jeep Compass (2006-2016 / MK 49, MK 1) Our video tutorials explain how to act independently in the face of a problem with your vehicles. Today's video is about resetting the oil light on a…
How to Reset the Maintenance Light on a 2021 Jeep Compass?
How to Reset the Maintenance Light on a 2021 Jeep Compass?
Jeep Compass (2016-2025 / 552, MK 2) In this video tutorial, see how to reset the engine oil change light on a 2021 Jeep Compass by following a few simple steps: first, perform maintenan…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos