Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Cherokee
    4. : How do you replace the outside rearview mirror on the Jeep Cherokee?

Jeep Cherokee - Video tutorial

Model: Jeep Cherokee XJ, MK 2 - Years 1984-2001
Part: Outside rearview mirror
Operation: How do you replace the outside rearview mirror on the Jeep Cherokee?

In order to replace the outside rearview mirror of the Jeep Cherokee you have to loosen the bolts located in the lower part of the armrest, so that the entire door panel can be removed. Once the panel has been detached from the door, it will be possible to disconnect the connector corresponding to the mirror and consequently also to loosen the bolts that secure it from the inside. When the mirror has been released, it will be possible to remove it from the outside of the door, installing the new one and fitting the door panel.


Posted on 1 October 2022 by ScegliAuto



How to replace the outside rearview mirror on the Jeep Cherokee?
Jeep Cherokee (1984-2001 / XJ, MK 2) In order to replace the rear-view mirror of the Jeep Cherokee, the door panel must be removed by loosening the screw located inside the internal hand
Replace the remote control battery of the Jeep Cherokee
Jeep Cherokee (2013-2023 / MK 5, KL) Does the battery of the Jeep Cherokee need to be replaced because it is flat? How to do? We open the remote control of the Jeep. We extract the metal
Where is the battery located in the Jeep Grand Cherokee?
Jeep Cherokee (2013-2023 / MK 5, KL) The Jeep Grand Cherokee, unlike other car models in the same category, has the battery located in a different location. Specifically, the battery of

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos