Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Cherokee
    4. : Outside rearview mirror

Jeep Cherokee - Outside rearview mirror

Jeep Cherokee (1984-2001 / MK 2, XJ)
How do you replace the outside rearview mirror on the Jeep Cherokee?
In order to replace the outside rearview mirror of the Jeep Cherokee you have to loosen the bolts located in the lower part of the armrest, so that the entire …read all…
Posted on 1 October 2022 by ScegliAuto
Jeep Cherokee (1984-2001 / MK 2, XJ)
How to replace the outside rearview mirror on the Jeep Cherokee?
In order to replace the rear-view mirror of the Jeep Cherokee, the door panel must be removed by loosening the screw located inside the internal handle …read all…
Posted on 15 March 2024 by ScegliAuto
Airbags (2) Alternator (2) Shock absorbers (1) Car stereo (8) Battery (8) Spark plugs (3) Control unit (1) Key (15) Timing belt (5) V-belt (3) -board computer (30) Checks and maintenance (29) Bearing (1) Mass air flow sensor (1) Headlight (4) Tail light (3) Air filter (5) Cabin air filter (9) Diesel filter (3) Hand brake (3) Light bulb (2) Headlight bulb (13) Rear light bulb (6) Interior lights ceiling light bulb (2) Handle (2) Engine (4) Window motor (1) Starter motor (3) Gear oil (2) Engine oil (7) Door panel (11) Windshield (2) Front bumper (2) Rear bumper (2) Brake pads (4) Hydraulic pistons (2) Gear Shift Knob (1) Pump (1) Fuel pump (3) Window lift button (1) Instrument cluster (9) Radiator (3) Passenger compartment heating radiator (3) Wheel (4) Fuse box (16) Seat (3) Drive shaft (1) Parking sensors (1) Suspensions (1) Outside rearview mirror (2) Windscreen wipers (2) Central tunnel (1) Steering wheel (2)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos