Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Cherokee
    4. : Engine

Jeep Cherokee - Engine

Jeep Cherokee (2008-2012 / MK 4, KK)
Main causes of engine power loss
If your car progressively loses power under acceleration while you are driving, this condition may depend on a number of factors. Certainly correct routine …read all…
Posted on 16 September 2023 by ScegliAuto
Jeep Cherokee (1984-2001 / MK 2, XJ)
Engine compartment electrical system adjustment
To arrange the electrical system inside the engine compartment, it is necessary to have good knowledge of general electronics and above all to be able to read …read all…
Posted on 1 September 2023 by ScegliAuto
Jeep Cherokee (2002-2007 / KJ, MK 3)
Check engine control unit operation
The car presented in the video shows an anomaly that is decidedly out of the ordinary since with the ignition on, almost all the warning lights on the …read all…
Posted on 21 August 2023 by ScegliAuto
Jeep Cherokee (1984-2001 / MK 2, XJ)
How to diagnose a problem with the first cylinder
This video shows what a good mechanic's approach must be in dealing with troubleshooting when there are no lights on and no faults are found in memory. The …read all…
Posted on 20 August 2023 by ScegliAuto
Airbags (2) Alternator (2) Shock absorbers (1) Car stereo (8) Battery (8) Spark plugs (3) Control unit (1) Key (15) Timing belt (5) V-belt (3) -board computer (30) Checks and maintenance (29) Bearing (1) Mass air flow sensor (1) Headlight (4) Tail light (3) Air filter (5) Cabin air filter (9) Diesel filter (3) Hand brake (3) Light bulb (2) Headlight bulb (13) Rear light bulb (6) Interior lights ceiling light bulb (2) Handle (2) Engine (4) Window motor (1) Starter motor (3) Gear oil (2) Engine oil (7) Door panel (11) Windshield (2) Front bumper (2) Rear bumper (2) Brake pads (4) Hydraulic pistons (2) Gear Shift Knob (1) Pump (1) Fuel pump (3) Window lift button (1) Instrument cluster (9) Radiator (3) Passenger compartment heating radiator (3) Wheel (4) Fuse box (16) Seat (3) Drive shaft (1) Parking sensors (1) Suspensions (1) Outside rearview mirror (2) Windscreen wipers (2) Central tunnel (1) Steering wheel (2)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos