Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Cherokee
    4. : V-belt

Jeep Cherokee - V-belt

Jeep Cherokee (1984-2001 / MK 2, XJ)
How to replace the drive belt in the Jeep Cherokee?
In this tutorial, we can see how to replace the service belt in the Jeep Cherokee, a very simple operation but one that requires good manual skills. First of …read all…
Posted on 5 November 2023 by ScegliAuto
Jeep Cherokee (1984-2001 / MK 2, XJ)
How to replace the serpentine belt on the Jeep Cherokee MK2
In this video tutorial we will see how to disassemble and replace the serpentine belt of the second series Jeep Cherokee, following these simple steps. First …read all…
Posted on 13 July 2022 by ScegliAuto
Jeep Cherokee (1984-2001 / MK 2, XJ)
How to replace the service belt on a Jeep Cherokee
Before we can begin, we will have to open the front hood, in order to obtain the necessary space to work. Let's start by removing the front fan, unscrewing the …read all…
Posted on 25 March 2024 by ScegliAuto
Airbags (2) Alternator (2) Shock absorbers (1) Car stereo (8) Battery (8) Spark plugs (3) Control unit (1) Key (15) Timing belt (5) V-belt (3) -board computer (30) Checks and maintenance (29) Bearing (1) Mass air flow sensor (1) Headlight (4) Tail light (3) Air filter (5) Cabin air filter (9) Diesel filter (3) Hand brake (3) Light bulb (2) Headlight bulb (13) Rear light bulb (6) Interior lights ceiling light bulb (2) Handle (2) Engine (4) Window motor (1) Starter motor (3) Gear oil (2) Engine oil (7) Door panel (11) Windshield (2) Front bumper (2) Rear bumper (2) Brake pads (4) Hydraulic pistons (2) Gear Shift Knob (1) Pump (1) Fuel pump (3) Window lift button (1) Instrument cluster (9) Radiator (3) Passenger compartment heating radiator (3) Wheel (4) Fuse box (16) Seat (3) Drive shaft (1) Parking sensors (1) Suspensions (1) Outside rearview mirror (2) Windscreen wipers (2) Central tunnel (1) Steering wheel (2)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos