Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install the Rear Camera on the Jeep Compass?

Model: Jeep Compass 552, MK 2 - Years 2016-2025
Part: Parking sensors

By purchasing a kit with a rear camera specific to your vehicle, you can install it by following the steps below: essentially, you will replace the standard "number plate light" strip with one that houses the rear camera. The strip you need to remove is the complete one (the one with the Jeep logo). Undo the 4 screws located on the sides and gently unclip the various clips. Take the new panel, install it in place of the old one, and route the power cables with the connectors through the flexible grommets above the tailgate, leading to the dashboard through the roof and one of the pillars.

Updated on 25 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Oil Change Light on a Jeep Compass
How to Reset the Oil Change Light on a Jeep Compass
Jeep Compass (2016-2025 / 552, MK 2) Before you can start, sit in the driver's seat of your Jeep Compass. Begin by activating the instrument cluster without starting the engine by pressi…
How to Replace the Front Headlight Bulb of a Jeep Compass
How to Replace the Front Headlight Bulb of a Jeep Compass
Jeep Compass (2006-2016 / MK 1, MK 49) Before you begin, open the front bonnet of your Jeep Compass. Start by disconnecting the electrical connector attached to the blown bulb, using a fla…
How to Replace the Front Headlight on a Jeep Compass
How to Replace the Front Headlight on a Jeep Compass
Jeep Compass (2006-2016 / MK 1, MK 49) Before starting, open the front bonnet of your Jeep Compass. Begin by disassembling and removing the front bumper by unscrewing the fastening screws …

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos