Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Front Driveshaft

Model: Jeep Grand Cherokee ZG, MK 1, ZJ - Years 1992-1998
Part: Axle shaft

This guide shows how to replace a driveshaft. After securing the car on axle stands, proceed to remove the affected wheel and then remove the hub by unscrewing the three screws that hold it in place. As shown in the video, this operation can be tricky if there are any rust deposits, so it is advisable to have a good penetrating spray on hand. Finally, once the hub is removed, slide out the damaged driveshaft and proceed with its replacement. This operation is not for everyone, so it is wise to research thoroughly before deciding to intervene; the video guide refers to a Jeep Grand Cherokee.

Updated on 2 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Dismantle the Front Differential of a Jeep Grand Cherokee
How to Dismantle the Front Differential of a Jeep Grand Cherokee
Jeep Grand Cherokee (2010-2021 / WK2, MK 4) Below are the instructions that will allow you to dismantle and replace the front differential of a Jeep Grand Cherokee. First, lift the vehicle and …
How to disassemble the front headlight on the Jeep Grand Cherokee
How to disassemble the front headlight on the Jeep Grand Cherokee
Jeep Grand Cherokee (2010-2021 / WK2, MK 4) These short and simple steps will show us how to disassemble and replace the front headlight of the Jeep Grand Cherokee. First, we open the hood and …
Removing the Front Headlamp of a Jeep Grand Cherokee 2
Removing the Front Headlamp of a Jeep Grand Cherokee 2
Jeep Grand Cherokee (1998-2004 / MK 2, WJ) In this video, you will see how to remove and replace the front headlamp assembly of a second series Jeep Grand Cherokee by following these simple st…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos